Consists of S.S. holders in mainfold of 3 of 6 to
hold 47 m.m. dia,. membrane filters, The tops of the holders are connected
to the outlets of the flushing tube with silicone tubing and glass stop
cock. A vacuum resistant flask or woulf bottle must be placed between the
manifold and vacuum pump. (Supplied without Wolfs Bottle and Vaccum/
Pressure Pump). These units are used for sterlity testing when the membranes
filter is to be removed from the holder for incubation in culture media.
Filtration areas is 12.5cm and has a holding capacity of 250ml. Though only
vacuum is required for filleration , some pressure is required for flushing
liquids.
- 3 Branch Sterility Test Unit. (Made from SS-316)
- 6 Branch Sterility Test Unit (Made from SS-316)
Optional Accessories
- Monoblock Vcuume -cum-Low Pressure Pump
- Oil Free Vacuume Pump
Fitted with a FHP motor, it can accommodate six
sieves of 8" dia. Speed can be regulated Through a continuously
variable speed regulator fitted to the unit. To work on 220/230 volts A.C.
(Without Sieves)
- For 8" dia sieves
- For 12" dia sieves
Optional Accessories
- Automatic 0-60 minute "GERMAN" Timer
- Digital Timer
To carry upto 7 sieves of 8" dia it is driven
by 1/4 HP electric motor, through reduction gear. The sieve table doesn't
rotate but is inclined from the vertical axis the direction. In addition to
the gyratory motion of the table, there is an upward and downward movement
ensuring that each square inch of the sieve is utilised. To works on on
220/230 Volts single phaseAC. Supplied complete with adaptor for 8"
sieves but withouttest sieves
Optional Accessories
- Adaptor for 12" Sieve
- Automatic 0-60 minute "German" Timer
- Digital Timer
To carry upto 7 sieves of 8" dia it is driven
by 1/4 HP electric motor, through reduction gear. The whole gear mechanism
which gives circular end to end motion runs in oil bath. The tapping motion
is given by hammer from top. Works on 220/230 volts single phase AC.
Supplied complete with adaptor for 8" sieve but without test sieve.
Fitted with AUE/GE/CROMPTION/EQUIVALENT MOTOR.
Optional Accessories
- Automatic 0-60 minute "German" Timer
- Digital Timer
This yoder type motor driven sieve shaker is for
carrying out wet sieve analysis of material. Consists of a water reservior
and a holder for sieve which can take upto 7 sieve of 8" dia. The
shaker is driven by 1/4 HP motor through a belt drive. Suitable to operate
on 230 volts, 50 cycles, single phaseA.C.
- For 1 set
- For 2 sets
- For 4 sets
Optional Accessories
- Automatic 0-60 minute "GERMAN" Timer
